3M

Every carton of 60 connectors contains a free Assembly Tool. No Polish LC Connector provides fast on-site installation of 250 μm and 900 μm terminations...

The Hot Melt ST Fiber Optic Connector is a keyed bayonet style multimode/single-mode connector, compatible with ST connectors, which incorporates 3M™ hot melt adhesive and pre-radiused PC zirconia...

Scotch® Detectable Buried Barricade Tape 407 - CAUTION BURIED FIBER OPTIC LINE BELOW, Aluminum Backing with Orange Striping and Black Letters Adhesive Material Clear Film...

Product Description3M™ FP-301 Tubing offers an outstanding balance of electrical, physical and chemical properties for a wide variety of industrial and military applications. Rated for 135°C...

The 8602-S Hot Melt LC is a singlemode simplex connector designed for termination of 1.6 to 2.0 millimeter jacketed cable. A blue simplex latch actuator, shrink tube strain relief, and single white...

The SC Connector is designed for the most advanced fiber optic systems requiring exceptional stability, low reflections (single-mode) and high density. The SC connector is available in single-mode...

The 6650-LC Expansion Kit contains the necessary tools to terminate the Hot Melt LC and must be used in conjunction with the 6366/6362-230V Hot Melt Termination Kit. Expansion kit includes (4) hot...

CONNECTOR LC MULTIMODE HOT MELT DUPLEX 1.6-2.0 CABLE WHITE/BEIGE BOOT. The 6602-D Hot Melt LC is a multimode duplex connector designed for termination. The BTW design is for Behind-The-Wall...

The Hot Melt Termination Kits 6365 and 6361 contain all materials necessary to terminate 3M, SC, ST, and FC Hot Melt and Ultra High Temp Hot Melt Connectors. There are also conversion kits that make...

The SC Connector is designed for the most advanced fiber optic systems requiring exceptional stability, It is also available in multimode preloaded with Hot Melt adhesive, enabling a field...

The FC/PC Connector is a field mountable, pull-proof connector that is fully compatible with all PC connectors adhering to the NTT specification.

After the fiber is inserted, the assembly tool depresses the cap to force clamping and locating surfaces against the fiber, locking and aligning the fiber in place.